Milwaukee Angle Grinder Adaptor M14 - 1/2" x 20mm

Milwaukee Angle Grinder Adaptor M14 - 1/2" x 20 - Pack of 1

Technical data:

For hole saws: 22 - 29 mm
Clamping shank: M14
Hole saw or drill bit clamp: 1/2 "x 20

How to use with an angle grinder:
1. Screw the M14 adapter into the hole saw and tighten firmly with a wrench. Then use the shaft retainer on the angle grinder and the adapter directly onto the thread and fasten it tightly with a wrench
2. If the tile is not fixed to the floor or wall, in this case fasten it tightly with any clamping tool
3. Dip the tip of the hole saw into water.
4. Set the angle grinder to the highest speed. Slowly approach the tile with the hole saw at an angle of 20 to 30 °, pressing lightly to avoid scratching. As the hole saw begins to cut the tile and form the groove, we gradually begin to move the hole saw in a perpendicular direction until it is perpendicular to the tile.
5. Dip the hole saw in water every 5 seconds.
6. Make light circular motions during cutting for maximum life.